Filter
Top Products
Solution 64
14
Bosch Security Systems 09/06 BLCC110U
User Guide
Main Office A001
Disarmed
Press OK or MENU
If the area is turned All On, the keypad will display:
Main Office A001
Armed All On
If the area is turned Part On, the keypad will display:
Main Office A001
Armed Part On
3. To exit, press [OK].
Areas > Commands >
Turn Area On/Off
MENU 2-0-1
This menu allows you to turn an area All On or off.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [1].
A list of different areas will display on the keypad.
A001 Reception Area
A002 Sales Dept
A003 Administration Dept
Press , OK or MENU
If an area has already been turned All On or Part On, a
‘tick’ (
) will be displayed on the right side of the name
description (see A002 Sales Dept above).
2. Use the [↑] and [↓] keys to select the area that you want
to turn on or off, then press [OK] to select. Alternatively,
you can enter the area number you want to turn on or off,
then press [OK].
Areas > Commands >
Turn All Areas On
MENU 2-0-2
This menu allows you to turn on all areas that your PIN has been
assigned to at the same time All On. The keypad display below
shows the area icons 1 through to 8.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [2].
The keypad will display the exit time bar to prompt you
to exit all areas. You should leave all areas now.
Area 1 Name
EXIT
NOW
When exit time has expired, the keypad will display that
all areas are turned All On (Armed).
Area 1 Name
ARMED
Fri,Aug,13 5:34 pm
i
Note
Area icons will only display if programmed to
do so by your security installer.
Areas > Commands >
Turn All Areas Off
MENU 2-0-3
This menu allows you to turn off all areas that your PIN has been
assigned to at the same time. However, this menu requires at
least one area that has a keypad assigned to it to be disarmed
before you can access this command.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [3].
Areas > Commands >
Move To Area
MENU 2-0-4
This menu allows you to operate multiple areas from the same
keypad when the system has been partitioned. Before operating
a different area, you will need to move the keypad to the area
that you want to operate.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [4].
A list of different areas will display on the keypad.
A001 Reception Area
A002 Sales Dept
A003 Administration Dept
Press , OK or MENU
2. Use the [
↑] and [↓] keys to select the area that you want
to move the keypad display to, then press [OK] to select.
Alternatively, you can enter the area number that you
want to move the keypad display to, then press [OK].