Filter
Top Products
Solution 64
16
Bosch Security Systems 09/06 BLCC110U
User Guide
Inputs > Commands >
Bypass Zones
MENU 3-0-2
This menu allows you to bypass or un-bypass a single or multiple
zones before you turn the area All On, Part On or Part 2 On.
When bypassing zones, it disables the ability for a zone to detect
intrusion and sound an alarm.
A burglary zone will automatically become un-bypassed when
you turn the corresponding area off (disarm). Any 24-Hr fire or
24-Hr non fire zones will need to be manually un-bypassed.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [3] + [0] + [2].
A list of zones that can be bypassed will display on the
keypad. A ‘√’ displayed on the right side of the zone
name indicates that the zone is already bypassed.
Z001 Zone 1 Name
Z002 Zone 2 Name
Z003 Zone 3 Name
Press OK or MENU
2. Use the [
↑] and [↓] keys to select the zone that you want
to bypass, then press [OK]. Alternatively, you can enter
the zone number that you want to bypass, then press
[OK].
If the zone is bypassed, the keypad will prompt:
Zone 1 Name Z001 is
bypassed. To un-bypass,
press OFF.
Press OK or MENU
If the zone is not bypassed, the keypad will prompt:
Zone 1 Name Z001 is
un-bypassed. To bypass,
press ON.
Press OK or MENU
3. Press [ON] or [OFF] to toggle the zone to be bypassed/un-
bypassed.
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Repeat steps 1 to 4 to bypass or un-bypass additional
zones.
Inputs > Commands >
Set Chime Zones
MENU 3-0-3
This menu allows you to program zones to be monitored when
the system is turned off. Chime mode is ideal to monitor a front
door to sound the keypad buzzer when opened (faulted).
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [3] + [0] + [3].
A list of areas will display on the keypad.
2. Use the [
] and [] keys to select the area that you want
to program zones for chime mode, then press [OK].
Alternatively, you can enter the area number that you
want to program chime zones, then press [OK].
The keypad will list all zones that can be programmed for
chime mode. A ‘
’ displayed on the right side of the zone
name indicates that the zone is already set for chime.
Z001 Zone 1 Name
Z002 Zone 2 Name
Z003 Zone 3 Name
Press OK or MENU
3. Use the [
↑] and [↓] keys to select the zone that you want
to set for chime, then press [OK]. Alternatively, you can
enter the zone number that you want to set for chime,
then press [OK].
If the zone is not programmed for chime, the keypad will
prompt:
Zone 1 Name Z001
Zone Chime is OFF,
To turn ON, Press ON.
To Go Back Press OK
If the zone is programmed for chime, the keypad will
prompt:
Zone 1 Name Z001
Zone Chime is ON.
To turn OFF, Press OFF.
To Go Back Press OK
4. Press [ON] or [OFF] to toggle the zone to be monitored
when chime mode is turned on.
5. Press [OK] to save and exit, or press [MENU] to exit
without saving.