Filter
Top Products
Instruction manual SGE 67
gis
11 Main menu
11.1 Introduction
The
MENU
is reached by pressing the button on the
controller.
The main menu comprises:
•
OFF
Select this option if you wish to shut the water
heater down (10 "
Shutting down") for a brief
period, but do not wish to drain it. In this mode, the
frost protection is active. This prevents water from
freezing in the water heater.
•
ON
In this mode, the water heater continually
responds to the hot water
demand (11.3 "
Switching to "ON mode"").
•
WEEK PROGRAM
Select this option to allow the water heater to
respond to demand only during pre-programmed
periods (11.5 "
Week program"). Outside those
periods, only frost protection is active.
•
EXTRA PERIOD
Select this option to overrule
OFF
mode or
PROG
mode (i.e. Week program) so that a single
temporary period (11.10 "
Extra period") of heat
demand will be fulfilled.
•
SETTINGS
Select this option to set (11.11 "
Settings") the
language and the time. You can also use this
option to display the regulation interval
(temperature), and the ignition and working
speeds of the fan.
Note
If you fail to make any selection with the main
menu open, then after 30 seconds, the water heater
will automatically return to the mode it was previously
in.
11.2 Notation convention for menu-related
instructions
The
MENU
( ) of the controller is divided into sub-
menus. For example,
SETTINGS
is one of the
functions reached from the main menu. The menu
SETTINGS
is itself divided into sub-menus. For
example,
LANGUAGE
is a sub-menu of
SETTINGS
.
So, for example, to select menu
LANGUAGE
, this
manual employs the following convention:
• :
SETTINGS
|
LANGUAGE
Confirm with .
This means:
1. : Activate the main menu with .
2.
SETTINGS
: Using button and/or go to
SETTINGS
and confirm with .
3.
LANGUAGE
: Using button and/or go to
LANGUAGE
4. Confirm with . After pressing ,
you will have activated sub-menu
LANGUAGE
.
11.3 Switching to "ON mode"
You can switch the water heater to
ON
mode from any
operational mode, as follows:
1. :
ON
|
START OPERATION
Confirm with .
Note
Also refer to the chapter on starting the water
heater (9 "Starting the water heater").
11.4 Setting the water temperature
11.4.1 Setting the water temperature via
the SET POINT MENU
Set the water temperature via:
1. :
ON
|
CHANGE SETPOINT
Confirm with .
MENU
»OFF
^ ON
È WEEK PROGRAM
EXTRA PERIOD
SETTINGS
START OPERATION
^»CHANGE SETPOINT
È Tset=65ÉC