Filter
Top Products
Instruction manual SGE 57
gis
7 The control panel
7.1 Introduction
This chapter covers the following topics:
• Control;
• Explanation of icons
;
• ON/OFF switch on controller
;
• Navigation buttons;
• PC connection
.
7.2 Control
The control panel is completely menu-driven, and
comprises:
• a 4-line display with 20 characters per line;
• 6 buttons for controlling the water heater (below
the display);
• 6 graphical symbols (above the display);
• a connector for a service PC;
• an ON/OFF switch.
The buttons are divided into three groups:
• Navigation buttons:
- Buttons for UP , and DOWN ;
-Enter: ;
- Reset button:
• The main menu (11 "
Main menu"): ;
• the service program (12 "
Service program"): .
This chapter is specifically intended for the service
and maintenance engineer and installation
engineer.
In this manual, the display of the controller is shown as
in the figure, both with and without icons.
7.3 Explanation of icons
The table explains the meanings of the icons.
Icons and their meaning
7.4 ON/OFF switch on controller
The ON/OFF switch of the controller turns the water
heater ON and OFF. Note that in the OFF position the
water heater remains electrically live, in order for the
continuous pump to stay running.
After switching on, the text
INTERNAL CHECK
appears on the display for about 10 seconds. The
main menu (11 "
Main menu") then appears. If no
selection is made in the main menu, the water heater
automatically switches to the OFF
mode (8.2 "
Operating modes").
Note
To electrically isolate the water heater, you must
use the isolator between the water heater and the
mains power supply.
»START OPERATION
^ CHANGE SETPOINT
È Tset=70ÉC
a
Name Explanation
Heat demand Heat demand
detected
Purge Pre- and post-purge
using fan
Pressure switch Pressure switch is
closed
Glow (Pre)glow
Gas control valve Gas control valve
open/ignition
Flame detection Water heater
operational
Solar heating
system
Solar energy is
heating the water
INTERNAL CHECK