Filter
Top Products
Installation
19
F232122
Instructions for Installation of
Cabinet Freestanding Models
(UFPV) with Water Saving System
Read the following instructions thoroughly before
proceeding. The installer must have a comprehensive
understanding of the instructions before attempting
installation of the WSS.
Refer to the WSS Electrical Specifications for voltage
information.
Refer to the WSS General Specifications to determine
if there is adequate clearance through the door for the
machine. If not, removal of the water tanks is
necessary.
1. Removing the water tanks (if necessary):
a. Remove the three cap plugs located near the
rear and one located near the front on each
side of the tanks. Refer to Figure 8.
b. Loosen the two hose clamps attached at the
bottom rear of each tank. Refer to Figure 8.
c. Loosen the hoses clamps attached to the
elbow at the rear of each tank and slide off the
long black hoses that run from the tanks.
Refer to Figure 9.
d. Loosen the hose clamp to the short black hose
between each tank and remove from only one
tank.
Figure 8
Q007I
1 Water Tanks
2 Vacuum Vents
3 Water Saving Control Housing
4 Cap Plug
5 Hose Clamps Under Tank, Behind Plug
3
2
1
4
5