A SERVICE OF

logo

259
Chapter 18 Timebase Counter
6.Settings
6. Settings
*: For the setting procedure, refer to the section indicated by the number.
Settings required to specify the oscillation stabilization wait time for the main clock
See “Chapter 22 Main Oscillation Stabilisation Timer (Page No.289)”.
Settings required to specify the PLL lock wait time
See “Chapter 19 Timebase Timer (Page No.263)”.
Table 6-1 Settings Required to Specify the Oscillation Stabilization Wait Time
Setting Setting register
Setting
procedure*
Oscillation stabilization wait time setting Standby control register (STCR) See 7.1.
Table 6-2 Settings Required to Setup an INITX Pin Reset
Setting Setting item Setting procedure
INITX pin input
Refer to the oscillator parameters and the reset
parameters in the Data Sheet.