Filter
Top Products
31
4. On the Wayne-Dalton Z-Wave®
Enabled Thermostat press the SAVE
ENERGY mode. The thermostat must be
in either HEAT or COOL, SAVE ENERGY
mode, to be added to the network
correctly.
5. On the Wireless Gateway, press
and hold the SCENE button you wish
to program, (either Scene 1, 2 or 3 but
choosing a different SCENE than in Step
2) for SAVE ENERGY mode. The LED
on the Wireless Gateway will turn on
immediately, then turn off, then turn on
again.
6. While holding the desired SCENE
button on the Wireless Gateway, press
and release the BIND button on the
thermostat.
The LED on the Wireless Gateway will
flash three (3) times quickly to indicate
the programming is successful. Do not
release the Scene button until you see
the LED’s flash (30 second max wait.)
Thermostat programming to the Wireless
Gateway is now complete.
OPERATING THERMOSTAT:
1. Place the thermostat in either the
HEAT or COOL mode by manually
pressing the appropriate button.
2. Press the controller SCENE button
you programmed for NORMAL target
temperature to activate the NORMAL
mode, or press the controller SCENE
button you programmed for SAVE
ENERGY to activate the SAVE ENERGY
mode.
See the Wireless Gateway User Manual
for directions on operating Scenes and
key chain remote operation.
REMOVING THERMOSTAT FROM
WIRELESS GATEWAY (primary
controller):
Remove the thermostat from the Wireless
Gateway as you would remove any
Z-Wave
® module. Use the BIND button
the same as the PROGRAM button, to
activate the Z-Wave
® signal. See the
Wireless Gateway User Manual for
specific instructions.
Z-Wave® Programming
Example with WDHA-12R
AUTO
ON
FAN
HEAT
COOL
SAVE
ENERGY
NORMAL
RESET
COOL
4
Programming Examples
Scene 1
Scene 2
Scene 3
Delete
Copy
5
AUTO
ON
FAN
HEAT
COOL
SAVE
ENERGY
NORMAL
RESET
COOL
6