Filter
Top Products
Programming
Programming Target Temperatures
(continued)
Programming COOL SAVE target
temperature:
NOTE: If this is not the rst time set-
up, place your thermostat into COOL
mode. If the display is showing the
word HEAT, press the COOL button
to change to COOL mode. The LCD
will display the word COOL.
10. With the word COOL displayed on
the LCD, press and release the SAVE
ENERGY button. TARGET TEMP and
SAVE will appear in the display.
11. The default COOL SAVE ENERGY
target temperature is 80º F. To accept
the default temperature wait 5 seconds
and the unit will exit target temperature
programming mode. If the default
setting is not desired, press either the
temperature up button (+ symbol) or
temperature down button (- symbol)
until the desired target temperature is
reached. Wait 5 seconds and the unit
will exit target temperature programming
mode and remain in COOL SAVE mode
and display the actual ROOM TEMP.
25
NOTE: Your Wayne-Dalton thermostat is designed to
maintain your target temperature within 1 degree.
In HEAT mode, if the temperature falls more than
1 degree below the target temperature, your HVAC
system will turn on and then shut off when the
temperature rises above the target by 1 degree.
In COOL mode, if the temperature rises more than
1 degree above the target temperature, your HVAC
system will turn on and then shut off when the
temperature falls below the target by 1 degree.
AUTO
ON
FAN
HEAT
COOL
SAVE
ENERGY
NORMAL
RESET
COOL
AUTO
ON
FAN
HEAT
COOL
SAVE
ENERGY
NORMAL
RESET
SAVE
10
11