Filter
Top Products
Tools Needed:
31
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
INSTALLATION
hex head lag screws and 5/16” bolts
with nuts (may not be supplied), fabricate
rear support for horizontal tracks. Attach
horizontal tracks to the rear supports with
5/16”-18 x 1-1/4” hex bolts and nuts (may
not be supplied). Horizontal tracks must be
level and parallel with door.
NOTE: If rear supports are to be installed
over drywall, use 5/16” x 2” hex head lag
screws.
NOTE: If an idrive
®
opener will be
installed, position horizontal tracks one
hole above level when securing it to rear
supports.
Adjust weather seal (if necessary).
Permanently attach the weather seal to
both door jambs and header. (Temporarily
attached in PREPARING THE OPENING on
page 10.) Avoid pushing weather seal too
tightly against face of door.
Now, lift door and check it’s balance.
Adjust, if door lifts by itself (hard to pull
down) or if door is diffi cult to lift (easy to
pull down). Anytime spring adjustments
are made you must loosen the lock nuts
and retighten both lock nuts afterwards.
To adjust spring(s), only add or remove 1/4
turn on the counter at a time. Adjust both
sides equally.
IMPORTANT: DO NOT ADD OR REMOVE
MORE THAN 1 SPRING TURN FROM
SPECIFIED AMOUNT. IF THE DOOR STILL
DOES NOT OPERATE EASILY, LOWER
THE DOOR INTO THE CLOSED POSITION,
UNWIND SPRING(S) TO ZERO, AND
RECHECK THE FOLLOWING ITEMS:
1.) Check the door for level.
2.) Check the
TorqueMaster
®
spring tube
and fl agangles for level and plumb.
3.) Check the distance between the
fl agangles - must be door width
plus 3-3/8” to 3-1/2”.
4.) Check the counterbalance cables
for equal tension - adjust if
necessary.
5.) Rewind the spring(s).
6.) Make sure door isn’t rubbing on
jambs.
NOTE: As a safety feature, the right hand
end bracket cannot be disassembled
for service until the spring is completely
unwound and the counter cover reads
zero.
After door installation is completed, refer
to the idrive
®
owner’s manual.
Rear Support Continued...
PERFORATED ANGLE
(3) 5/16”
BOLTS & NUTS
HORIZONTAL TRACK
BOLT MUST EXTEND INTO
THE TRACK TO SERVE AS
A ROLLER STOP
12” ANGLE
30” ANGLE - BOLTED
USING (2) 5/16” X 1-5/8”
HEX HEAD LAG SCREWS
TO CEILING MEMBER AND
PARALLEL TO DOOR
SOUND FRAMING MEMBERS
SOUND FRAMING MEMBERS
HORIZONTAL TRACK
12” ANGLE
BOLT MUST EXTEND INTO
THE TRACK TO SERVE AS
A ROLLER STOP
30” ANGLE - BOLTED
USING (2) 5/16” X 1-5/8”
HEX HEAD LAG SCREWS
TO CEILING MEMBER
AND PARALLEL TO DOOR
JAMB
WEATHER
SEAL
PERMANENTLY ATTACHED
WEATHER SEAL OR DOOR STOP