Filter
Top Products
23
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
INSTALLATION
Drive Gear Installation
End Brackets
Lubricating Oil
36 Tooth Worm
Gear
Beginning with the right hand side,
lubricate entire circumference of the 36
tooth worm gear with the lubricating oil
provided. Slide the 36th worm gear
onto the winding shaft splines until it
touches the flagangle.
NOTE: On single spring applications,
no drive gear is required on the left
side.
NOTE: If additional lubricating oil is
needed, use “Dura Lube
®
Engine Oil
Treatment”.
WINDING
SHAFT
SPLINES
FLAGANGLE
36 TOOTH
WORM GEAR
WINDING
SHAFT
CABLE
DRUM
CABLE
DRUM
IMPORTANT: WARNING TAGS MUST BE
SECURELY ATTACHED TO BOTH END
BRACKETS.
Slide the right hand end bracket over
the drive gear and fasten to the
flagangle using a #10 self-tapping
screw. Drill 3/16” pilot holes into jamb
for the lag screws. Secure end bracket
and the flagangle to the jamb using (2)
5/16” x 1-5/8" lag screws.
Repeat for left hand side.
(2) 5/16” X 1-5/8”
LAG SCREWS
#10 PHILLIPS
HEAD
SCREW
WARNING
TAG
Power Drill
3/16” Drill Bit
7/16”
Socket Driver
Phillips Head
Screwdriver
END BRACKET
21
22
LUBRICATING
OIL
36 TOOTH
WORM GEAR