Filter
Top Products
Tools Needed:
18
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Attaching Quick Install Flagangle
to Horizontal Track
NOTE: If you have fully adjustable fl agangle,
skip this step and complete Step 15.
To install horizontal track, place the curved
end over the top roller. Align key slot of the
horizontal track with the quick install tab
of the fl agangle. Push curved portion of
horizontal track down to lock in place.
DO NOT RAISE DOOR UNTIL HORIZONTAL
TRACKS ARE SE CURED AT REAR, AS
OUTLINED IN STEP 34, OR DOOR COULD
FALL FROM OVERHEAD POSI TION CAUSING
SEVERE OR FATAL INJURY.
Level the horizontal track assembly and
bolt the horizontal angle to the slot in the
fl agangle using (1) 3/8” - 16 x 3/4” truss
head bolt and (1) 3/8” - 16 hex nut. Repeat
for other side. Remove the nail that was
temporarily holding the top section in place,
installed in Step 13.
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE TO
TOP SECTION.
NOTE: If an
idrive
®
opener will be installed,
position horizontal tracks slightly above level.
NOTE: After completing this step, continue
with Step 16.
KEY
SLOT
QUICK
INSTALL
TAB
HORIZONTAL
TRACK
VERTICAL
TRACK
FLAGANGLE
Top Section
Place the top section in the opening
and vertically align with lower sections.
Temporarily secure the top section by
driving a nail in the header near the
center of the door and bending it over the
top section. Now fl ip up hinge leaf, hold
tight against section, and fasten center
hinges fi rst, and end hinges last. (Refer
to Step 8). When installing a door with a
TorqueMaster
®
counterbalance system,
vertical track alignment is critical.
Position fl agangle between 1-11/16” (43
mm) to 1-3/4” (44 mm) from the edge
of the door. Flagangles must be parallel
to the door sections. Now complete the
vertical track installation by securing the
center jamb bracket and tightening the
other lag screws. Repeat for other side.
IMPORTANT: THE DIMENSION BETWEEN
THE FLAGANGLES MUST BE DOOR-
WIDTH PLUS 3-3/8” (86 MM) TO 3-1/2”
(89 MM) FOR SMOOTH, SAFE DOOR
OPERATION.
13
14
Hammer
DOOR WIDTH
+3-3/8” TO 3-1/2”
FLAGANGLE
TOP
SECTION
NAIL
WARNING
9/16” Socket
Ratchet Wrench
9/16” Wrench
Level
KEY SLOT
QUICK
INSTALL
TAB
HORIZONTAL
TRACK
VERTICAL
TRACK
FLAGANGLE
3/8” - 16 X 3/4”
TRUSS HEAD BOLT
3/8” - 16 HEX NUT
HORIZONTAL TRACK
HORIZONTAL ANGLE
1-11/16”
TO 1-3/4”