Filter
Top Products
3
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Package Contents
(1)TORQUEMASTER
®
SPRING TUBE
DOOR SECTIONS (AS REQUIRED)
(2) TOP BRACKET SLIDE
1/4”-14 X 5/8” SELF TAPPING
SCREW (AS REQUIRED)
1/4”-20 X 11/16” SELF DRILLING
SCREW (AS REQUIRED)
(4) 1/4”-20 X 5/8”
CARRIAGE BOLTS
(4) 1/4”-20 X 9/16” LARGE
HEAD RIBBED TRACK BOLTS
(2) #12 X 1/2” PHILLIPS
HEAD SCREWS
(2) VERTICAL
TRACK RH/LH
(1) 3/8” - 16 NYLOCK
NUT (IF INCLUDED)
(2) 3/8”-16 X 3/4”
TRUSS HEAD BOLT
(1) CENTER BRACKET
ASSEMBLY
(2) QUICK INSTALL RH/LH
FLAGANGLE (AS REQUIRED)
(2) FULLY ADJUSTABLE RH/LH
FLAGANGLE (AS REQUIRED)
(2) HORIZONTAL TRACK RH/LH
NOTE: DEPENDING ON THE DOOR MODEL, SOME PARTS LISTED WILL NOT BE SUPPLIED IF NOT
NECESSARY. REAR SUPPORTS MAY OR MAY NOT BE INCLUDED WITH YOUR DOOR.
ROLLERS
(AS REQUIRED)
COUNTER COVERS
(AS REQUIRED)
IDRIVE
®
OPERATOR
(SOLD SEPARATELY)
(1) OPERATOR BRACKET
LUBRICATING OIL
(AS REQUIRED)
(2) HORIZONTAL ANGLE
(21-15/16” OR 80”)
(AS REQUIRED)
(2) TOP BRACKET BASE
PULL ROPE
(IF INCLUDED)
COUNTER GEAR
(AS REQUIRED)
5/16” X 1 5/8” HEX HEAD LAG SCREW
(AS REQUIRED)
(1) LOOSE WINDING SHAFT
(SINGLE SPRING ONLY)
3/8”- 16 X 3/4” HEX HEAD
BOLT (IF INCLUDED)
RIGHT AND LEFT CABLE
DRUM ASSEMBLIES
WEATHER SEAL & NAILS
(IF INCLUDED)
ASYMMETRICAL U-BAR
(IF INCLUDED)
RIGHT & LEFT
DRUM WRAPS
TorqueMaster
®
- Single and Double Spring
Installation Instructions and Owner’s Manual
9100, 9600, 5120, 5140
IMPORTANT NOTICE!
Read these instructions carefully before
attempting installation. If in question about
any of the procedures, do not perform the
work. Instead, have a qualifi ed door agency
do the installation or repairs.
© Copyright 2005 Wayne-Dalton Corp. Part No. 302868 Rev. 2 08/04/2005
MANUAL 1/4”- 20 FLANGED HEX
NUT (AS REQUIRED)
RIGHT & LEFT
END BRACKETS
U-BAR
(IF INCLUDED)
Q.I. JAMB BRACKETS
(AS REQUIRED)
STUD PLATE
(IF INCLUDED)
(2) 3/8”- 16 HEX NUT
36 TOOTH WORM GEAR
(AS REQUIRED)
(2) #10 PHILLIPS
HEAD SCREWS