Filter
Top Products
jamb, fit the weatherstrip up tight against the temporarily attached weatherstrip in the header
and flush with the inside edge of the jamb. Temporarily secure the weatherstrip with equally
spaced nails. Repeat for other side. This will keep the bottom section from falling out of the
opening during installation. Equally space nails approximately 12” to 18” apart.
For Fully Adjustable track: For the header, align the weatherstrip 1/8” to 1/4” inside the header
edge, and temporarily secure it to the header with equally spaced nails. Starting at either side
of the jamb, fit the weatherstrip up tight against the temporarily attached weatherstrip in the
header and 1/8” to 1/4” inside the jamb edge. Temporarily secure the weatherstrip with equally
spaced nails. Repeat for other side. This will keep the bottom section from falling out of the
opening during installation. Equally space nails approximately 12” to 18” apart.
Headroom requirement: Headroom is defined as the space needed above the top of the door
for tracks, springs, etc. to allow the door to open properly. If the door is to be motor operated,
2-1/2” (64 mm) of additional headroom is required.
NOTE: 6” low headroom conversion kit is available for 12” radius only. Contact your local
Wayne-Dalton dealer.
Backroom requirement: Backroom is defined as the distance needed from the opening back
into the garage to allow the door to open fully.
BACKROOM REQUIREMENTS
DOOR HEIGHT TRACK MANUAL LIFT MOTOR OPERATED
6’5” to 7’0” 12”,15” Radius 98” (2489 mm) 125” (3175 mm)
7’1” to 8’0” 12”,15” Radius 110” (2794 mm) 137” (3480 mm)
HEADROOM REQUIREMENTS
TRACK TYPE SPACE NEEDED
15” Radius track 13-1/2” (343 mm)
12” Radius track 11” (279 mm)
6” LHR Kit 6” (152 mm)
Weatherstrips
Level header
Finished
Door width
Jambs
Backroom
Plumb
jambs
Finished
Door
Height
Nail
Headroom
Header board 2”x 6”
lumber preferred
Suitable mounting surface
2”x 6” lumber minimum
Weather-
strips
Weather-
strips
Jamb
Quick Install track
Fully Adjustable track
Jamb
1/8” to 1/4”
Min. Side
room
Clearance
is 3 1/2”
Min. Side
room
Clearance
is 3 1/2”
5
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer,
refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com