Filter
Top Products
19
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
INSTALLATION
TorqueMaster
®
Spring Tube
TorqueMaster
®
springs come lubricated
and pre-assembled inside the
TorqueMaster
®
spring tube. To install, lay
the TorqueMaster
®
spring tube on the
floor (inside garage) in front of the door
with the labeled end to the left.
LABELED END
TORQUEMASTER
®
SPRING TUBE
None
15
16
Center Bracket Bushing
NOTE: If you are installing the idrive
®
opener on your garage door, skip this
step and continue with Step 17.
NOTE: If you are not installing an idrive
®
opener on your garage door, you must
install the center bracket bushing
assembly. Follow these instructions for
non-idrive
®
operated garage doors.
NOTE: If you are installing a
DoorMaster
™
opener, see optional
DoorMaster
™
Bracket installations on
page 31, Figure A.
Being cam shaped the center bracket
bushing only fits one way.
Slide the center bracket assembly
towards the center of the TorqueMaster
®
spring tube, from the right side as
shown.
NOTE: Upon completion of this step,
continue with Step 18.
CENTER
BRACKET
ASSEMBLY
TORQUEMASTER
®
SPRING TUBE
TORQUEMASTER
®
SPRING TUBE
CENTER
BRACKET
BUSHING
None