Filter
Top Products
15
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
INSTALLATION
Top Brackets
(4) 1/4” - 14 x 5/8”
SELF TAPPING
SCREWS
TOP BRACKET BASE
TOP BRACKET SLIDE
(2) 1/4” - 20
FLANGED HEX
NUTS
(2) 1/4” - 20 x 5/8”
CARRIAGE BOLTS
ROLLER
TOP BRACKET SLIDE
Power Drill
7/16” Socket
Driver
1ST SET
2ND SET
To install the L-shaped top brackets,
align the top holes in the top bracket
base with the second set of holes in the
endcap.
Fasten using (4) 1/4” - 14 x 5/8” self
tapping screws. Secure the top bracket
slide to the bracket base loosely using
(2) 1/4” - 20 x 5/8” carriage bolts and
(2) 1/4” - 20 flanged hex nuts. The
bracket will be tightened and adjusted
in Step 14. Insert rollers into top bracket
slide. Repeat for other side.
8
TOP SECTION
TOP SECTION
TOP SECTION
NOTE: If you have a model 5120 or 5140
series door with windows in the top
section, skip this step and complete Step
10.
NOTE: Model 5120 series door over 13’
wide require a 3” u-bar (supplied).
Place the 3” u-bar over the top rib of the
top section. Fasten each end of the u-bar
to the endcap with (2) 1/4”- 20 x 11/16”
self drilling screws.
Fasten center of the u-bar as shown
to the rib using (2) 1/4”- 14 x 5/8” self
tapping screws one 6” to the left and one
6” to the right of the center of the door
section.
NOTE: After completing this step,
continue with Step 11.
U-Bar
(2) 1/4”-20 X 11/16”
SELF DRILLING SCREWS
Power Drill
7/16” Socket
Driver
(2) Saw Horses
9
U-BAR
OPERATOR BRACKET
(INSTALLED IN THE STEP 11)
TOP DOOR SECTION
6”
6”
ATTACHING CENTER OF U-BAR ATTACHING ENDS OF U-BAR
(2) 1/4”-14 X 5/8”
SELF TAPPING
SCREWS