Filter
Top Products
VIVOTEK
User's Manual - 103
recording feature will activate the frame rate control. When enabled, recording takes place by recording
only the I-frames (1x Intra-frame is recorded for every 1/2, 1, 2, or 4 seconds). And the full-frame-rate
recording immediately takes place when a Motion Detection, DI, or Manual trigger is triggered. This
feature is not directly related to the event notication settings in Applications > Event.
Priority: Select the relative importance of this recording setting (High, Normal, and Low).
Source: Select the recording source (stream 1 ~ 4).
Trigger: Specify the triggering condition.
■ Schedule: the recording takes place following the recording schedule below.
■ Network fail: the recording takes place by writing data to the onboard SD card in the event of a
network failure.
Recording Schedule: Specify the recording duration.
■ Select the days of the week.
■ Select the recording start and end times in a 24-hr time format.
Destination: You can select the SD card or a networked storage that has been congured for storing the
video les.
The following options apply to NAS only:
Entire free space: Specify the length of the individual recorded clip.
Reserved space: Specify a minimum of 50MB of reserved space if you select the Cyclic recording
option. The camera needs a transaction space when the storage media is about to be lled up and
the new videos are still coming.
Enable cyclic recording: Select this checkbox so that the storage space can be recycled when the
recording eventually lls up the storage space.
Recording le management: You can either choose the entire free space available or limit the reserved
space. The recording size limit must be larger than the reserved amount for cyclic recording.
Maximum duration: Specify the length of the individual recorded clip.
Maximum le size: Specify the maximum le of each recorded clip. The sizes can be among 1 to 300
megabytes.
File name prex: Specify a prex as the beginning of the video clip’s le name.
If you want to enable recording notication, please click Application to set up. Please refer to Trigger >
Recording notify on page 91 for detailed information.
When completed, select Enable this recording. Click Save to enable the setting and click Close to exit
this page. When the system begins recording, it will send the recorded les to the Network Storage.
The new recording name will appear in the drop-down list on the recording page as shown below.
To remove a recording setting from the list, select a recording name from the drop-down list and click
Delete.