Filter
Top Products
28 Chapter 3 Setting Up and Putting Away the System GE Inspection Technologies XLG3 VideoProbe System
6. Remove the insertion tube.
7. Attach the handset to the handle.
a. Slide the handset holder into either of the sockets. (There are sockets on both
sides of the handle.) The holder clicks into place.
b. Unwrap handset cable and remove handset. Slide handset into the holder,
aligning the grooves in the back of the handset with the holder. Swivel the holder
into the desired position.
c. Lock the swivel ball in position. (The lock holds the handset firmly in position while
still letting you turn it from side to side.)
8. Install the desired optical tip. Then snap probe end into the clip near the handset.
See “Changing the Optical Tip” on page 31.