Filter
Top Products
Eng-41
3-7) NETWORK SETTING function and setting method
This section of the manual is intended for users who will install this security system in a network
environment.If you have difficulty setting the network,we recommend contacting your network administrator.
•
Function: Allows users to select the STATIC (fixed) IP, DHCP, PPPoE of Setting.
•
Setting method: Move to #7, NETWORK SETUP MENU by using ▲/▼ KEY in the SETUP
MENU, then press the ENTER SWITCH to display the OSD as shown in the figure below.
(The figure shows the initial setting status)
MOVE TO EACH item by using ▲/▼ KEY, and using
œœ
/
√√
KEY to change the set value.
Static IP User
- Constituted by Static IP on the TCP/IP network
1) Move to ‘STATIC...’ by using ▲/▼ KEY at NETWORK ACCESS, then press ENTER SWITCH
to set STATIC...
(STATIC : Select in case the network configuration of monitor is fixed IP (Public or Private IP)
2) Move to IP ADDR / GATEWAY / SUBNETMASK by using ▲/▼ KEY.
3) Press ENTER SWITCH and type in IP ADDR / GATEWAY / SUBNETMASK respectively.
4) DNS 1 and DNS 2 will be automatically set to DNS as shown above.
Use
œœ
/
√√
KEY to change it.
06/01/03 13:14:00
NETWORK SETTING
1. NETWORK ACCESS STATIC.../DHCP.../PPPoE...
2. HTTP PORT 00080
NETWORK STATUS
IP ADDR 192.168.1.200
GATEWAY 192.168.1.65
SUBNETMASK 255.255.255.0
DNS 1 168.126.63.001
DNS 2 168.126.63.002
MAC ADDR 00:30:6f:ff:00:00
06/01/03 13:14:00
STATIC ACCESS
IP ADDR 192.168.1.200
GATEWAY 192.168.1.65
SUBNETMASK 255.255.255.0
DNS 1 168.126.63.001
DNS 2 168.126.63.002
• Static
• DHCP
• DSL (PPPoE)