Filter
Top Products
Eng-24
5. Align the two holes of the caserear
to the holes of the plastic anchors,
and then fasten the screw tappings
(BH M3 X 30).
6. Adjust the direction of the lens.
1) Use a the philips head screwdriver
to turn the screw (indicated by
the arrow in the illustration)
counterclockwise slightly.
The lens body will move.
2) Tilt the lens body down about
10° from the horizontal, and
then turn the screw clockwise
to fasten it.
7. Assemble the assy-case front onto
the case rear as shown in the
illustration. Fasten the assy-case
front to the case-rear with the
screw (BH M2.6) you removed
earlier.
SCREW-
TAPPING
G(BH M3 x 30)
SCREW-TAPPING
G(BH M3 x 30)
Screw
(HB M4 x L8)
CASE-REAR
Screw (BH M2.6) ASSY-CASE
FRONT