Regency G36D-NG NATURAL GAS Indoor Fireplace User Manual


 
UltraGlow G36D Zero Clearance Direct Vent Gas Fireplace
24
CONVERSION KIT FROM NATURAL GAS TO PROPANE MODEL #290-969
FOR G36D USING SIT 820 NOVA GAS VALVE
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
Remove the 2 screws, push Burner
Assembly to the left and lift out.
Conversion Kit Contains:
Qty. Part # Description
1 910-018 SIT Conversion Kit-50%
Turndown LP
1 910-037 LP Injector (Pilot Orifi ce)
1 904-345 Burner Orifi ce #53
1 908-255 Decal "Converted to Propane"
1 908-528 Red "PROPANE" label
1 908-529 5/32" Allen Key
1 918-165 Instruction Sheet
1) Shut off the gas supply.
2) Remove the louvers (and bay door if it is
installed).
3) Open the fl ush door and remove the door.
4) Remove the logs and embers.
5) Remove the 2 screws holding the Burner
Assembly to the fi rebox base. Push the
Burner Assembly to the left and lift out.
6) Pull off the pilot cap to expose the pilot
orifi ce.
Burner Orifi ce
7) Unscrew the pilot orifi ce with the allen key
and replace with the LP pilot orifi ce in the
kit and replace pilot cap.
9) Reinstall new burner orifi ce LP stamped #53
and tighten.
10) Remove and discard the 3 pressure regula-
tor mounting screws (A), pressure regulator
tower (B) and diaphragm (C).
11) Insure that the rubber gasket (D) is properly
positioned and install the new HI/LO pres-
sure regulator assembly to the valve using
the new screws (E) supplied with the kit.
Tighten screws securely.
12) Reverse steps 5) to 2).
13) Attach clear label "This unit has been con-
verted to Propane" near or on the serial #
decal. Attach white label "This valve has
been converted from NG to LPG using SIT
conversion Kit Code 0.907.202" onto the
valve.
14) Replace yellow "Natural Gas" label with red
"Propane" label
15) Check for gas leaks.
16) Check inlet and outlet pressures.
17) Check operation of fl ame control.
18) Check for proper fl ame appearance and glow
on logs.
8) Remove burner orifi ce with a 1/2" wrench
and discard. Use another wrench to hold
on to the elbow behind the orifi ce.
INSTALLATION