5100-I ACT WOOD INSERT
R
438-0380E
April 21, 2010
D. Flue Draft Considerations
Location of the appliance and chimney will affect perfor-
mance. As shown in Figure 6.1 on page 6 the chimney
• Be installed through the warm space enclosed by the
the affects of wind turbulence.
-
ing attic joists.
Exterior conditions such as roof line, surrounding trees,
o be sure that your appliance burns properly, the chimney
draft (static pressure) should be approximately -.10 inch water
column (W.C.) during a high burn and -.04 inch W.C. during
a low burn, measured 6 inches (152mm) above the top of the
appliance after one hour of operation at each burn setting.
NOTE
F. Inspect Appliance and Components
E. Tools And Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available.
• Open the appliance and remove all the parts and
• Inspect all the parts and glass for shipping damage.
•
Contact your dealer if any irregularities are noticed.
• Removed all labels from the glass doors.
Reciprocating saw
Level
Gloves
self drilling screws (you will
need 3 per pipe section
connection +10)
Inspect appliance and components for
damage. Damaged parts may impair safe
operation.
WARNING
Report damaged parts to dealer.