Quadra-Fire 5100I-NL-B Indoor Fireplace User Manual


  Open as PDF
of 44
 

5100-I ACT WOOD INSERT
R
438-0380E
April 21, 2010
Minimum Width of Cavity Opening 36 914
 24 607
 19 483
Inches Millimeters
      

• 
may be removed to accommodate a direct-connect starter
pipe or chimney liner,
• External trim pieces which do not affect the operation of

     
removed.
•        
         

accommodate the insert, and must be returned to original
       Figure
17.2.
• 
the portion of the insert extending onto the hearth must be
supported.
•       
ordered from your dealer.
• 
the authority having jurisdiction.
Damper 
Ember Catches 
 Doors
The following parts may be removed:


 

• Re-install original factory built chimney cap

 
 

Prefabricated Metal Chimney (Cont’d)
LINER CONNECTOR
FLUE
GAS
DIRECTION
CRIMPED
END
TOWARDS
STOVE
Figure 17.1
NOTE:
-
places are NOT allowed.
NOTICE: In Canada when using a factory-built chim-
ney it must be safety listed, Type UL103 HT (2100
o
F)
[1149
o
C] CLASS “A” or conforming to CAN/ULC-
S629M, STANDARD FOR 650
o
C FACTORY-BUILT
CHIMNEYS.
NOTE: Refer to chimney liner manufacturer
for recommendations on supporting the liner.
Installtion into replaces without a permit will
void the listing.
G. Altering the Fireplace
H. Securing Chimney Components
-
tions must be attached to the insert and to each other with the
crimped (male) end pointing toward the insert. Figure 15.1.
WARNING! Risk of Fire!
Follow venting manufacturer’s clearances and instructions
when installing venting system.
250-2061
WARNING
THIS FIREPLACE MAY HAVE BEEN ALTERED
TO ACCOMMODATE AN INSERT. IT MUST BE
RETURNED TO ITS ORIGINAL CONDITION
BEFORE USE AS A SOLID FUEL BURNING
FIREPLACE.
250-2061
Figure 17.2
 previous next