5100-I ACT WOOD INSERT
April 21, 2010
R
438-0380E
1
Listing and Code Approvals
-
sion standards.
MODEL:
LABORATORY:
REPORT NO.
TYPE:
STANDARD:
A. Appliance Certication
C. Glass Specications
D. BTU & Efciency Specications
contact your dealer for replacement glass.
when not installed in a sleeping room and when an outside
the mobile home and use only listed double-wall connector
pipe. An Outside Air Kit comes standard on the appliance
and must be installed in a mobile home installation.
B. Mobile Home Approved
-
ranty, implied or stated, for the installation or mainte-
nance of this unit and assumes no responsibility for
NOTE:
In the absence of local codes you must comply with the
UL1482, (UM) 84-HUD and NFPA211
the ULC S628-93 and CAN/CSA-B365 Installation
Codes in Canada.
• Installation and use of any damaged appliance.
• Operating appliance without fully assembling all
components.
• Operating appliance without legs attached (if supplied with
unit).
Any such action that may cause a re hazard.
WARNING
Fire Risk.
responsibility for, and the warranty will be
EPA Certied:
Efciency: up to 84.4%
BTU Output: 11,600 to 48,200
Heating Capacity:
climate zone
Maximum Log Length: 12 inches
Firebox Capacity: 3.0 cubic feet
Weight: 520 lbs
this appliance, reserves the right to alter its products,