5100-I ACT WOOD INSERT
April 21, 2010
R
438-0380E
F. Prefabricated Metal Chimney
Figure 16.1
E. Metal Heat Circulating Masonry
• Must be minimum 6 inch (152mm) inside diameter of
o
installation.
for installation.
• Refer to manufacturers instructions for installation
for installation into listed factory-built zero
clearance
cap must be re-installed after installing the approved
full height listed chimney liner must be installed from the
and the chimney top.
air-cooled chimney system.
1.
this cannot be accomplished, it will be necessary to
remove the damper
connector with a high temperature sealant or seal
3. Both methods must be removable and replaceable
for cleaning and re-installation.
Minimum 8” (203mm) Masonry Thickness
in Front of Smoke Chamber
Damper Plate Removed or
Fastened in Open Position
Seal with Non-
Combustible Material
Minimum Clearance in Accordance with
Insert Listing
Floor Protection in
Accordance with Insert
Listing
Combustible Floor
Airtight Insulated Clean-Out
Stainless Steel Chimney Connector
Must Extend to Flue Liner
Flue Liner with Required Air Space
-