Filter
Top Products
14 Pelco Manual C1043M-A (2/96)
12345678910111213
14202122232425 19 18 161517
DB25 - BACK VI EW
PI N3 = RECEI VE ( Rx)
PI N7 = GRUND(
DB25 CONNECTOR
12345
6789
DB9 CONNECTOR
TO SMART
UNI T
DB9 - BACK VI EW
PI N3 T ANSMI T ( Tx )
PI N5 = GROUND ( Gnd)
OGnd)
=R
PRI NTER
4.8.7 Printer Parameters
From this menu the baud rate for the auxiliary output port
may be adjusted to communicate with an optional serial
printer. The Inter-Check
defaults to 9600 baud.
To edit the baud rate, press [7]. The following prompt
will appear:
Printer baud = 9600
Enter baud rate 1 - 19200?
Enter the desired baud rate for your printer.
Press [ENTER].
4.8.8 SET CLOCK
This function is used to set the internal clock to match
real time. To edit, press [8]. The following prompt will
be displayed:
1. Time
2. Date
• To set the time, press [1].
• Enter the correct military time separating each pair
of numbers by a colon.
• Press [ENTER] to save.
• To set the date, press [2].
• Enter the correct date separated by a slash.
• Press [ENTER] to save.
4.8.9 External Camera Select
This feature selects the screen (1 or 2) to be used for
controlling the Inter-Check switcher. The selected screen
will have an “S” displayed at the bottom.
• To change the settings, press [9]. The monitor will
display: Screen 1 or 2?”
• Select the desired screen. The following prompt will
appear: 1. on 2. off
• Press [1] for screen on or [2] for screen off.
4.8.9.1 Equivalent Camera Select
Hot Key F9
1. Press [F9]
2. Select appropriate Video Input mode
1 = Video Input 1
2 = Video Input 2
3 = Internal Sync
OR - For manual external camera selection on an Inter-
Check Switcher:
1. Press [F9]
2. Press [F9] again
3. Select appropriate camera from the Shadow List:
[1] = Selects the camera programmed into Shadow
List preshot #1
[2] = Selects the camera programmed into Shadow
List preshot #2, etc.
Figure 8. DB25 Printer Connector to DB9 ICI3000P Unit Pin Assignments
ICI3000P