Filter
Top Products
Pelco Manual C1043M-A (2/96) 13
4.8.6 Channel Program Menu
4.8.6.1 Partyline
Press [6]. The following prompt will be displayed:
CHANNEL PROGRAM MENU
4. Group Poll List
5. Exception Follow Alarm Time
6. Group Select
4.8.6.2 Channel Program Menu
1. Baud Rate — Not Applicable
2. RS-232 — Not Applicable
3. ISO-Jack — Not Applicable
Group Poll List
This selection will allow you to edit the eight-
register group you choose using Group Select in
the Channel Program group. This selection is used
if there are more than 16 registers in the system.
This list allows you to monitor any combination
of 16 registers.
For example, if you wish to monitor registers 1
through 8 plus registers 18 through 26, you would
select Group 2 using the Group Select menu op-
tion. Then select the Group Poll List menu option
and enter registers 18 through 26 to be monitored
in Group 2 rather than the default list which is 9
through 16.
The 16 registers to be monitored can also be se-
lected using Hot Key G and Hot Key B while in
the monitoring mode.
Hot Key G is used to select one of the four groups
of eight registers. The status bar at the bottom of
the video screen will show which screen is cur-
rently selected. If Group 2 is selected, for example,
the status bar will read:
G4 = 2.
Similarly, if you wish to select a block of registers
(16 registers), press Hot Key B. If Block 2 is se-
lected, for example, the status bar will read: B2 =
2. (Block 2 includes registers 17 through 32, which
is the same as Groups 3 and 4.)
Exception Follow Alarm Time
This option is used to set the length of time the
Inter-Check unit will dwell on an exception when
using the Exception Follow or Hot Key E. When
this option is selected, the video screen will dis-
play:
Alarm Dwell = 10
Enter Alarm Dwell Time 0 - 255
Group Select
This option is used to choose a group of eight reg-
isters in the poll list that you want to edit using the
Group Poll List menu option.