Filter
Top Products
- 47 -
Web setting screen
Problem Check points
The web setting screen
cannot be accessed.
≥ Turn on the unit or set it to Standby mode.
≥ Check if a valid IP address is set for the unit.
≥ After changing the IP address of the unit, enter [http://
Post-change IP address/] into the address bar of the web
browser.
≥ Make sure that you do not access a wrong IP address.
j[When using Windows]
Execute the Windows command prompt, ping [The IP
address set for the unit]. If a reply comes back from the
unit, there are no operational problems.
If a reply does not come back, restart the unit and
change the IP address using the Easy IP Setup
Software.
j[When using Mac OS X]
Using the Mac OS X terminal, execute ping -c 10 [The
IP address set for the unit]
If a reply comes back from the unit, there are no
operational problems.
If a reply does not come back, perform the following
steps.
1) Press the INIT button to initialize the network
settings of this unit.
2) Start the web setting screen to configure the network
settings.
jFor information on how to start the web setting screen,
please read the “Operating Instructions <Basics>.”
≥ Make sure that the HTTP port number is not set to 554.
For information on the HTTP port numbers supported by
the unit, refer to page 40.
≥ Check if the set IP address is not overlapping with that of
another device, and the set address match the network/
subnet of the connection destination.
j[When the personal computer is connected to the unit
within the same subnet]
Set the IP addresses of this unit and the computer to a
common subnet. Further, cancel the “Use proxy server”
setting on the web browser. When accessing this unit in
the same subnet, it is recommended that you set the
address of this unit as a “Remove from proxy” address.
j[When the unit and personal computer are connected
to different subnets]
Check if the default gateway value set for the unit is
correct.