Filter
Top Products
- 45 -
∫ It is not a malfunction in following cases
Troubleshooting
Object seems to be
warped.
≥ Object seems to be warped slightly when the object
moves across the image very fast, but this is because the
unit is using MOS for the image sensor. This is not a
malfunction.
When the flash is fired
during shooting, only
the top or bottom of the
screen becomes lighter.
≥ With a MOS image sensor, the shooting timing differs
slightly between the top left and bottom right of the
screen. This means that when the flash is fired, the
bottom of the screen will become lighter in the field
concerned and the top will become lighter in the next
field.
This is normal and not indicative of any problem.
Power
Problem Check points
This unit cannot be
turned on.
≥ When the status display lamp is off, power is not supplied
or the unit is turned off.
jCorrectly connect the AC adapter, the AC cable, and
the USB cable.
jPress the power button of the unit.
≥ When using the wireless remote controller, select the unit
by pressing one of the CAM1 to CAM4 buttons, and then
press and hold the ON/STANDBY button for 2 seconds.
≥ If you turn off the unit with the power button of the unit,
the unit cannot be turned on by the web setting screen,
the wireless remote controller or controller. Press the
power button to turn on the unit.