Filter
Top Products
35
Accessories
for OM5 Analog Modules
FEATURES
● SINGLE, DUAL, 8-, AND 16-POSITION BACKPANELS
● DIN RAIL MOUNT BACKPANELS
● 19-INCH MOUNTING RACK FOR BACKPANELS
● MULTIPLEXED AND NON-MULTIPLEXED BACKPANELS
● INTERFACE CABLES
● MODULE EVALUATION BOARD
● CABLE-TO-SCREW-TERMINAL INTERFACE BOARD
OM5-BP-16-C 16 POSITION ANALOG I/O BACKPANEL, NON-MULTIPLEXED
FIGURE 1. OM5-BP-16-C
Analog I/O Backpanel Dimensions.
SCM5B
SPECIFICATIONS
Operating Temperature: –40°C to +85°C
95% relative humidity, non-condensing
Interface Connector:
Field High Density Screw Clamp, 14 AWG Max
Logic 26-pin, male header connector
DESCRIPTION
The OM5-BP-16-C 16 channel backpanel (Figure 1) can accept any of the
OM5 analog modules in any mixture. It can be mounted on the OMX-1363-
C 19-inch metal rack. The OM5-BP-16-C has 16 non-addressable analog I/
O signal channels which provides each module with it’s own analog bus. The
module output switch is continuously “on” when using this backpanel and all
sixteen module outputs are simultaneously accessible to high-speed data
acquisition (ADC) boards. A set of inter-channel bridge jumpers permits
connecting an input module’s output to an output module’s input, providing
two levels of isolation. A temperature sensor is mounted on each channel to
provide cold junction compensation for thermocouple input modules (See
Figure 2 for schematic). Field connections are terminated with four screw
terminals at each module site. Use system interface cable OMX-1315-XX-
C for connection to the host system.
12345678910111213141516
17.4" (442.0mm)
17.1" (434.3mm)
11.3" (287.0mm)
7.6" (193.0mm)
3.9" (99.1mm)
0.15"
(3.8mm)
1.275"
(32.4mm)
26 Conductor Male Pin
Connectors P1, P2
(1)
3.47"
(88.1mm)
3.05"
(77.5mm)
Channel
2.27"
(57.7mm)
0.08"
(2.0mm)
0.75" (19.1mm)
0.093"
(2.4mm)
0.14" (3.6mm)
inside diameter
Pin 1
Pin 2
Pin 2
Pin 1
E3
JP15
P2P1
JP1
E2
E1
Inter-channel
Bridge Jumpers
+5VDC Supply
Sockets for Current Conversion Resistors, OMX-1362-C
OMX-CJC-C
Cold Junction
Compensation Circuit
10.32 X 0.40
Ground Lug, Including
Nut and Lockwasher
NOTES:
1. Connector is Berg 65863-075 or equivalent.
Mating Connector is Amp 49958-6 or equivalent.
Connectors P1 and P2 are wired in parallel for “daisy chaining” up to 4 boards.
Swaged Standoff
Thru Hole 0.15" (3.8mm) Dia.
J1 J2 J3
J4