Filter
Top Products
10-40
Page 52
2008-12-03
Note: On units equipped with a MH control unit (MHTC Flow, MHB Reflow, and MHTC
Reflow) malfunctions during operation are indicated by a corresponding event message in
the display. For that purpose, please observe the information given in the separate
operating instructions for the MH control unit.
2.2 NOTES ON FAULT ELIMINATION
In order to eliminate faults, the Nortec MH must be set out of operation
as described in this manual. Disconnect the unit from the mains and
secure the unit against in advertent power-up.
Only allow trained and qualified personnel to repair faults. Faults relating to electrical
installation must only be carried out by authorized personnel or your Nortec representative’s
service technician.
Repair work and replacement of faulty components must only be carried out by your Nortec
representative’s service technician!
3.0 TAKING OUT OF SERVICE / DISPOSAL
3.1 TAKING OUT OF SERVICE
If the Nortec MH must be replaced or if the humidification system is not needed any more,
proceed as follows:
1. Take the unit out of operation as described in this manual.
2. Have the unit (and all other system components, if necessary) un-mounted by a qualified
service technician.
3.2 DISPOSAL / RECYCLING
Dismantled components must be disposed of and/or recycled according to the local
regulations. In case of doubt please contact your Nortec supplier.