Filter
Top Products
10-20
Page 37
2008-12-03
1.3.2 Mounting the MH Control Unit
Figure 5. Mounting the MH Control Unit
1. Fix the control panel to the wall using 4 x ¼” screws (not provided).
2. Connect the multi conductor control cables from the hydraulic unit to the corresponding
terminals in the control unit according the appropriate wiring diagram.
Important: all cables must be lead into the control unit via strain reliefs installed into the
openings in the bottom of the control panel housing.
3. MH Reflow models – Connect the power cable from the pump motor to the
corresponding terminals according to the appropriate wiring diagram.