Filter
Top Products
Chapter 21: Remote Access
82
!
!
!
Use the information that you just wrote down for the next steps.
!
To access the LAN Menu select Advanced button, select Network from the
list on the left side of the screen, and then select the LAN tab.
!
!
!
!
!
!
!
!
!
!
!
• You can manually enter the IP address/DNS server information into
the DVR by selecting Use the following IP address.
• IP Address: Change this to the IP Address that you wrote down in
the previous section. You will have to enter a zero in front of any
numbers that do not have three digits. (Using the example from the
last section, the address would be 192.168.000.150 after the
necessary zeros are added.)
• Subnet Mask: This should be set to 255.255.255.000.
!
• Default Gateway: Change this to the router’s IP Address (Default
Gateway) that you wrote down in the previous section. You will
have to enter a zero in front of any numbers that do not have three
digits.
• DNS1: This will be filled in automatically.
!
• DNS2: This will be filled in automatically.
!
!
!
Write this information on the Information Log at the end of the
manual. Be sure to select Apply and restart the DVR to save all
changes.