Filter
Top Products
31
W415-0661 / C / 02.20.08
GRATE INSTALLATION
The grate for this
fi replace has been
removed for shipping
purposes.
The grate must be in-
stalled before the logs
are installed.
Remove the packag-
ing from the grate and
install onto the two pins
as illustrated.
GRATE
PINS
FIGURE 103
DOOR TRIM
The BGD42CF comes
complete with top door
trim
(W715-0729).
1. Guide the arms of the
trim into the slots that are
slightly hidden under the
facing through the open-
ing between the top of the
door and the bottom edge
of the facing as illustrated
in the front view.
2. Slide the arm into the slot
far enough to allow the front
edge of the trim to go in
behind the facing.
3. Let the bracket come
forward towards the back of
the facing and allow the trim
to rest on the inside lip, this
position will allow the notch
on the arm of the trim to
fall into place on the edge
of the slot.
NOTCH
INSIDE LIP
S
E
E
-
T
H
R
U
W
I
N
D
O
W
BGD42CF SIDE VIEW
BGD42CF WITH TOP DOOR TRIM INSTALLED
SLOT
TRIM
FACING
DOOR
BGD42CF FRONT VIEW
FIGURE 102a
FIGURE 102c
FIGURE 102b
LOG PLACEMENT
FIGURE 104
FIGURE 104
PHAZER
TM
logs and glowing embers, exclusive to Napoleon®
Fireplaces, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position the
glowing embers for a maximum glowing effect. Log colours may
vary. During the initial use of the fi replace, the colours will become
more uniform as colour pigments burn in during the heat activated
curing process.
1. Place the cutout in the bottom of log #1 behind the pilot assembly.
Rest the log against the back wall of the fi rebox.
FIGURE 105
FIGURE 105
2. Move the two small logs (#2 & #3) into position, lining up the studs
located on the burner with the holes on the bottom of the logs.
3. Tear the glowing embers into pieces and place along the front
row of ports covering all of the burner area in front of the small
logs (#2 & #3). Care should be taken to shred the embers into thin,
small irregular pieces as only the exposed edges of the fi bre hairs
will glow. The ember material will only glow when exposed to direct
fl ame; however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon
deposits and delayed ignition. PHAZERtm logs glow when exposed
to direct fl ame.
4. Place the bottom of the left crossover log (#4) onto the stud on
the left side of the log support. The top of the log should rest in the
pocket on the back log.
FIGURE 106
FIGURE 106
FIGURE 107
FIGURE 107
5. Place the bottom of the right crossover log (#5) onto the stud on
the right side of the log support. The top of the log should rest in
the pocket on the left crossover log (#4).