Filter
Top Products
30
W415-0661 / C / 02.20.08
DOOR LATCH
DOOR BRACKET
FIGURE 100
FIGURE 100
FINISHING
3. Place the bottom of the left crossover log (#4) against the left
fi rebox side and pulled forward to the grate.
The top of the log should rest in the pocket on the back log.
PHAZER
TM
logs and glowing embers exclusive to Napoleon® Fire-
places, provide a unique and realistic glowing effect that is different
in every installation. Take the time to carefully position the glowing
embers for a maximum glowing effect.
Log colours
may vary. During the initial use of the fi replace, Log
colours may vary. During the initial use of the fi replace the colours
will become more uniform as colour pigments burn in during the heat
activated curing process.
LOG PLACEMENT
TAB
SIDEVIEW
FIGURE 93
FIGURE 93
FIGURE 94
FIGURE 95
FIGURE 95
FIGURE 96
FIGURE 96
FIGURE 97
FIGURE 97
2. Move the two small logs (#2 & #3) into position, lining up the
studs located on the burner with the holes on the bottom of the
logs. Ensure that the small logs sit fl at on the burner.
BGD36CF FINISHING
1. Place the back log (#1) onto the log support
tray and in front of the tabs. The tabs maintain
an air space between the log and fi rebox back
to facilitate combustion air fl ow. Ensure that the
back of the log rests against the brackets on the
back wall of the fi rebox.
FIGURE 98
FIGURE 98
5. Place the bottom of the right crossover log (#6) against the right
fi rebox side and pulled forward to the grate. The top of the log
should rest in the pocket provided on the center log (#5).
BGD42CF FINISHING
DOOR INSTALLATION / REMOVAL
Open the Valve Access
Door. While holding the
door securely, release
the 4 latches along
the top of the door.
Tilt the door forward
and lift off of the
two brackets at the
bottom of the door.
When replacing the
door, rest the door on the
brackets ensuring that lip
of the brackets rest in the
groove in the bottom edge
of the door. Push the door
backward into place and
secure with the 4 latches.
4. Position the base end of the center log (#5) against the middle
grate post with the other end of the log resting in the pocket of the
left crossover log.
REMOVING THE VALVE ACCESS DOOR
1. The valve access door rotates on the
pins attached to the side frame. Lift the
valve access door off the pins to operate
the main glass door.
FIGURE 101
GLASS/DOOR REPLACEMENT
Only available as an assembly complete with frame W010-0770.
Glass not available seperately.
BGD36CF(G) GLASS/DOOR REPLACEMENT
FIGURE99
1. Place the door frame face down care-
ful not to scratch the paint.
2. Center the gasketed glass
inside the door frame with the
thick side of the gasket fac-
ing up.
3. Bend the glass retainers lo-
cated along the edge of the door
frame over the gasket holding
the glass in place. Careful not to
break the glass.