Filter
Top Products
16
When the system is restarted after 2 hours and more,
the operation mode is determined by the room temper-
ature at start-up of the operation.
8
MICROPROCESSOR CONTROL
Once the operation mode is set, the same operation mode
can be repeated by simply turning the
OPERATE/STOP(ON/OFF) button ON.
Indoor unit receives the signal with a beep tone.
When the system turns off, 3-minute time delay will operate to
protect system from overload and compressor will not restart
for 3 minutes.
8-1. “I FEEL CONTROL” ( ) OPERATION
(1) Press OPERATE/STOP(ON/OFF) button on the remote
controller. OPERATION INDICATOR lamp of the indoor
unit turns on with a beep tone.
(2) Select “I FEEL CONTROL”( ) mode with the OPERA-
TION SELECT button.
(3) The operation mode is determined by the room temper-
ature at start-up of the operation.
lighted
not lighted
Approx. 4-F
or more
Difference
between set
temperature
and room
temperature
Approx. 4-F
or less
This shows that the
air conditioner is
operating to reach
the target temperature.
Please wait until the
target temperature is
obtained.
This shows that the
room temperature is
approaching the
target temperature.
Operation stateIndication
Operation Indicator
Operation Indicator lamp
The operation indicator at the right side of the indoor
unit indicates the operation state.
INDOOR UNIT DISPLAY SECTION
• The following indication applies regardless of shape
of the indicator.
MS24WN MU24WN
Initial room temperature
more than 55-F,
less than 77-F
COOL mode of
“I FEEL CONTROL“
DRY mode of
“I FEEL CONTROL”
WIRELESS REMOTE CONTROLLER
ON/OFF
FAN
TOO
WARM
TOO
COOL
VANE
MODE
STOP
START
HR.
MIN.
WIDE VANE
LONG
I FEEL
COOL
DRY
PM
CLOCK
AM
RESET CLOCK
OPERATION SELECT button
FAN SPEED CONTROL button
OFF-TIMER button
HR. button
MIN. button
(TIME SET button)
ON-TIMER button
RESET button
VANE button
(Horizontal vane button)
CLOCK SET button
LONG button
WIDE VANE button
(Vertical vane button)
ON/OFF
TOO
COOL
PM
AM
TOO
WARM
FAN
Signal transmitting section
Operation display section
OPERATE/ STOP
(ON/ OFF)button
TEMPERATURE buttons
77-F or more
mode
● Once the mode is fixed, the mode does not change
by room temperature afterwards.
● Under the ON-TIMER ( ) operation, the mode
is determined according to the room temperature at
the set time the operation starts.
● When the system is stopped on the remote controller,
and restarted within 2 hours in “I FEEL CONTROL”
( ) mode, the system operates in previous mode
automatically regardless of the room temperature.
Example
Previous operation
COOL mode of
“I FEEL CONTROL” or
COOL mode
Restart
COOL mode of
“I FEEL CONTROL”
Operation timer chart
Example
Previous operation
COOL mode of
“I FEEL CONTROL”
or COOL mode
Operation timer chart
Restart
COOL or DRY mode of
“I FEEL CONTROL” that
determined by room
temperature at start-up
of the operation.
OB311--1.qxp 04.1.13 9:53 AM Page 16