Filter
Top Products
9
E
4.4. Drying (dehumidifying)
1 If the unit is off, press the ON/OFF button to turn it on.
A The ON indicator should light up.
2 Press the operation mode button and select the
drying mode .
B should be displayed.
3 If necessary, press
TEMP.
button to set the desired temperature.
See page 10 for details.
4 If necessary, press to specify the vertical angle at which the
air is blowing.
See page 14 for details.
5 If necessary, press button to set the timer setting.
See page 11 for details.
Note:
• When the room temperature is lower than 18°C, the drying mode
cannot be set.
• This reduces the operation level of the indoor fan.
See page 13 for details.
• There may be times when the airflow volume does not match the
display on the remote control unit.
4. Operation
4.5. Heating
1 If the unit is off, press the ON/OFF button to turn it on
A The ON indicator should light up.
2 Press the operation mode button and select the
heating mode .
B should be displayed.
3 If necessary, press
TEMP.
button to set the desired temperature.
See page 10 for details.
4 If necessary, press button to select a desired rate.
See page 13 for details.
5 If necessary, press to specify the vertical angle at which the
air is blowing.
See page 14 for details.
6 If necessary, press button to set the timer.
See page 11 for details.
The fan speed may differ from the set speed at the start of the heating
mode, during the defrosting mode, or after shutdown of the heating mode.
C “STAND BY” is displayed from the moment heating begins until warm air is
blown out.
D “DEFROST” is displayed during defrosting.
ON OFFCLOCK
FILTER
CHECK
TEST RUN
REMOTE CONTROLLER
PAR-JH240KA
TEMP. TIMER SET
ON/OFF
–
STAND BY
DEFROST
CENTRALLY CONTROLLED
˚C
CLOCK
ON OFF
˚C
1Hr.
NOT AVAILABLE
CHECK MODE
FILTER
CHECK
TEST RUN
1
A
B
2
45
3
ON OFFCLOCK
FILTER
CHECK
TEST RUN
REMOTE CONTROLLER
PAR-JH240KA
TEMP. TIMER SET
ON/OFF
–
STAND BY
DEFROST
CENTRALLY CONTROLLED
˚C
CLOCK
ON OFF
˚C
1Hr.
NOT AVAILABLE
CHECK MODE
FILTER
CHECK
TEST RUN
1
A
C
D
2
3
56 4
B