Filter
Top Products
13
E
4. Operation
4.8. Using the timer
ON OFFCLOCK
6) AUTO START Operation
1 Press
ON OFFCLOCK
button to make the following checks.
Check that the current time is correct.
Check that the automatic start time is correct.
Check that the automatic shutdown time is identical to the dis-
play A .
• For the selection of the time, see the previous page
(page 11)
.
3 Press button once to display C
ON
on the remote controller.
7) AUTO STOP Operation
1 Press
ON OFFCLOCK
button to make the following checks.
Check that the current time is correct.
Check that the automatic shutdown time is correct.
Check that the automatic start time is identical to the display A
.
• For the selection of the time, see the previous page
(page 11)
.
3 Press button to display D
OFF
on the remote controller.
4.9. Selecting a fan speed
1 Press button to select a desired fan speed.
• Each time you press the button, available options change with the
display A on the remote controller, as shown below.
Display
Available
Option (Fan Speed Switch)
Low - High
• In the drying mode , the selection of the fan speed is disabled.
• In the heating mode , the indoor fan continues running for approxi-
mately one minute to discharge any residual heat from the electric
heater; even after the operation has shut down.
ON OFFCLOCK
FILTER
CHECK
TEST RUN
REMOTE CONTROLLER
PAR-JH240KA
TEMP. TIMER SET
ON/OFF
–
STAND BY
DEFROST
CENTRALLY CONTROLLED
˚C
CLOCK
ON OFF
˚C
1Hr.
NOT AVAILABLE
CHECK MODE
FILTER
CHECK
TEST RUN
3 1
DC
A
ON OFFCLOCK
FILTER
CHECK
TEST RUN
REMOTE CONTROLLER
PAR-JH240KA
TEMP. TIMER SET
ON/OFF
–
STAND BY
DEFROST
CENTRALLY CONTROLLED
˚C
CLOCK
ON OFF
˚C
1Hr.
NOT AVAILABLE
CHECK MODE
FILTER
CHECK
TEST RUN
1
A