Filter
Top Products
10
E
4. Operation
4.6. Automatic (cooling / heating)
The AUTO mode starts with cooling or heating depending on the current
room temperature, higher or lower, than a selected temperature value
accordingly.
1 If the unit is off, press the ON/OFF button to turn it on.
A The ON indicator should light up.
2 Press the operation mode button to select the
automatic mode .
B should be displayed.
3 If necessary, press
TEMP.
button to set the desired temperature.
See page 10 for details.
4 If necessary, press button to select a desired rate.
See page 13 for details.
5 If necessary, press to specify the vertical angle at which the
air is blowing.
See page 14 for details.
6 If necessary, press button to set the timer.
See page 11 for details.
4.7. Selecting a temperature
TEMP.
ss
ss
s To decrease the room temperature:
1 Press
TEMP.
button to set the desired temperature.
A The selected temperature is displayed.
• Each time you press the button, the temperature value decreases by
1°C.
ss
ss
s To increase the room temperature:
1 Press
TEMP.
button to set the desired temperature.
A The selected temperature is displayed.
• Each time you press the button, the temperature value increases by
1°C.
• Available temperature ranges are as follows:
Cooling & Drying: 19 - 30°C
Heating: 17 - 28°C
Automatic: 19 - 28°C
Circulation: — (Not available)
ON OFFCLOCK
FILTER
CHECK
TEST RUN
REMOTE CONTROLLER
PAR-JH240KA
TEMP. TIMER SET
ON/OFF
–
STAND BY
DEFROST
CENTRALLY CONTROLLED
˚C
CLOCK
ON OFF
˚C
1Hr.
NOT AVAILABLE
CHECK MODE
FILTER
CHECK
TEST RUN
1
A
B
2
546
3
ON OFFCLOCK
FILTER
CHECK
TEST RUN
REMOTE CONTROLLER
PAR-JH240KA
TEMP. TIMER SET
ON/OFF
–
STAND BY
DEFROST
CENTRALLY CONTROLLED
˚C
CLOCK
ON OFF
˚C
1Hr.
NOT AVAILABLE
CHECK MODE
FILTER
CHECK
TEST RUN
1
A