21
RDV4136 Series Direct Vent Gas Fireplace
10010618
Only glass approved by CFM Corporation
should be used on this fireplace.
1. Turn the fireplace OFF (including the pilot)
2. If the unit has been operating allow time for the
components to cool.
3. Remove the valve access panel. (Fig. 37)
4. Rotate the two clamps securing the lower edge of
the frame by pulling out on the handles. (Fig. 38)
5. Tilt the glass frame out slightly at the bottom, lift the
frame up and away from the fireplace.
6. To replace the glass frame reverse the procedure.
• The use of any non-approved replacement glass will
void all product warranties.
• Care must be taken to avoid breakage of the glass.
• Do not operate appliance with glass front
removed, cracked or broken.
• Replacement glass (complete with frame
window) is available through your CFM
Corporation dealer and should only be installed
by a licensed qualified service person.
Operating Instructions
Glass Information
Window Frame Assembly Removal
�
Valve
Valve Access Panel
FP1847
Fig. 37 Remove valve access panel.
G584-501
Remove glass frame
2/99 djt
Clamps
Glass
Frame
Fire-
place
Front
Glass
Panel
Pull
Clamp
Hook
Glass Panel
G584-501
Fig. 38 Window frame assembly removal.
It is necessary to periodically clean the glass. During
start-up condensation, which is normal, forms on the
inside of the glass. This condensation causes lint, dust
and other airborne particles to cling to the glass surface.
Also initial paint curing may deposit a slight film on the
glass. It is therefore recommended that the glass be
cleaned two or three times with a non-ammonia based
household cleaner and warm water (We recommend
gas fireplace glass cleaner) within the first few weeks of
operation.
After the initial cleaning process the glass should be
cleaned two or three times during each operating
season depending on the environment in the house.
Clean the glass after the first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam glass.
Glass Cleaning