Filter
Top Products
1 Service (continued)
23
• Boost Increment - If a system heat call last longer than the
programmed boost time setting and there have been no Hot
Water Generation calls, the control will increase the water
temperature set point by the amount in this parameter. If
the system heat call continues through another time period,
the set point will be increased again. This will continue
until either the system heat call ends, a maximum of 20
increases has occurred, or the maximum set point has been
reached. Once the system heat call has been satisfied the set
point will revert back to its calculated setting. This
parameter can be changed by the user or the installer. The
temperature range of this parameter is 0° to 45°F. The
default value is 0°F. This feature will be active if this
parameter is set to anything other than 0°F.
Reference page 18 for information regarding changing
parameters.
Time - The time is displayed in the upper right-hand corner
of the display. It is displayed in 24 hour format. Reference
the night setback parameters on page 24 for information
regarding adjusting the date and time.
Back button - Pressing this button will back the screen up to
the previous screen.
Service Manual