Filter
Top Products
50
Button Sewing
Machine Setting
Pattern: 08 (Mode 1)
Thread tension:3-7
Presser foot: Satin stitch foot F
Foot pressure: 3
Feed dog: Dropped
Unthread the needle thread.
Adjust the stitch width so that the needle enters both
holes in the button.
Place a button on the fabric and lower the needle by
turning the handwheel, so that the needle enters into the
left hole in the button.
Align the holes in the button with the slot on the foot and
lower it to hold the button in place.
Turn the handwheel to lower the needle into the right
hole in the button.
Adjust the stitch width if necessary.
Rethread the machine and sew about 10 stitches.
NOTE:
The LCD screen shows a warning to raise the feed dog,
but depress the foot control again to start sewing.
Raise the presser foot and remove the fabric.
Trim both needle and bobbin threads at the beginning.
Cut both threads leaving 20 cm (8”) tails.
Pull the bobbin thread to bring the needle thread to the
wrong side of the fabric then knot the threads.
1 Needle Thread at the Beginning
2 Bobbin Thread
3 Needle Thread
1
2
3