Filter
Top Products
Other Site Hardware
5–5
Honeywell recommends that cable not be “T-tapped”; this can introduce
unwanted distortion into the video signal.
To obtain a video feed, use an output port on the Multi video unit.
5.4.3 Configuring PTZ
You can use other PTZ hardware and its software driver at another site. For software
driver and baud rate, see table 13.
Configure each PTZ unit to communicate at its default baud rate. See the Rapid Eye
Multi-Media Admin User Guide for procedures to enable a PTZ dome.
Table 13
PTZ drivers for controllers and domes
Driver name
(alphabetical )
Baud rate Supported controller/dome
Javelin 308 9600 Javelin 308 Controller and others
Kalatel 9600 or 2400 Kalatel KTD 312 Cyberdome
Pelco D 4800*, 9600, or 2400 Pelco D: many domes
Pelco P 2400 Pelco P: many domes
Rapid Dome/Orbiter
†
9600 RapidDome or Orbiter
Sensormatic RS422
§
4800 SensorMatic RS422: Delta and Speed
Ultrak (using VCL) 2400 Ultrak (configured as VCL)
* A value of “4800” is typical; other values can be used as needed.
†
In other versions, this driver is jav306 or Javelin/ADEMCO.
§
This driver’s name was “Delta” in older versions of View.
After selecting a driver for PTZ, adjust the domes post-use behavior by using View
software and running a Maintenance session. The settings are on the Video tab.
Fig. 44. Video tab: PTZ settings.