Filter
Top Products
Field Work
2–9
!18 To change a LocalView password
1. After locking a LocalView function, as explained in procedure !17, click that
function’s Password button. A window appears showing a virtual keypad.
2. Using the virtual keypad, enter a number. The password's length can be
between 4 and 10 digits.
3. Click OK.
Please make a note of passwords. A lost password can make the LocalView
interface unchangeable.
Default LocalView passwords
To lock a Cycle: 1111.
To lock the LocalView setup: 9999; this password can be used to also unlock a cycle of
the Live tabs.
To lock the availability of making a clip: 1111.
The LocalView passwords have no effect on other passwords, set using Admin
software. See the Admin User Guide for procedures involving other passwords.
Very low recording rates
Table 5 shows some limits that a Multi SA needs to impose on cycle times for low
recording rates only when using LocalView.
Table 5
Restriction for LocalView cycle times when setting low recording rates
recording rate (fps) lowest cycle time (sec.)
0.25
16
0.5
8
1.0
4
2.7 Network Connection
Overview
You may not need to assign an IP address to a unit if your network is enabled for
Dynamic Host Configuration Protocol (DHCP).
Networks with DHCP
Multi-Media units can be enabled as DHCP clients; DHCP is OFF by default. After
enabling DHCP, power-down a unit connected to the network and power-up. See the
Admin User Guide for detailed procedures.
A network administrator has the option of assigning a reserved IP address to a Multi-
Media unit, instead of a “computer name”. In that case, the unit’s default IP address can
be used. You have the option of assigning a different static IP address to the unit using
the procedures for networks without DHCP, below.