Filter
Top Products
Section 5. Testing the 4500 With the 4286 Phone Module
5-3
2. Obtain phone access from the phone module. Enter the 2-digit phone
code. Enter the 4-digit system code if prompted.
3. Press # 99 on the phone keypad after the complete status announcement.
4. The 4286 will announce: “Thermostat Mode.”
The temperature setting for thermostat #1 will follow. You can change its set
point using menu selection 1 below. If thermostat #1 is in BYPASS or
CHECK, that status will be announced instead of the set point. The 4286 will
also announce whether set-back has been turned off by the user.
Menu Selections
“To change temperature, enter 1.” This selection is used to set the armed
away set-back temperature for thermostats #1 or #2 (This menu selection
will NOT be announced if the thermostat is in “CHECK or BYPASSED”)
• To allow the user to change the ARMED AWAY set-back temperature
settings, the 4286 will announce the present setting in effect, and wait for
a new 2-digit temperature setting to be entered. If the current
temperature setting is acceptable to the user, the user may press the ✴
key to advance without changing the setting.
• If the number entered is outside the allowed range (45° to 99° F., 07° to
37° C), a buzzer will sound from the phone, and the temperature setting
repeated. This will continue until the number entered is within the
allowable range.
• If the 4500 is BYPASSed, the user must switch the ACTIVE/BYPASS
slide switch on the 4500 front panel to the ACTIVE position, which will
then allow access through the 4286 thermostat menus.