Filter
Top Products
Section 4. Programming the 4286 to Add Thermostat(s)
4-3
If
The System
Contains
Addressable
Keypad
Non-
Addressable
Keypad
Select “MUTE”
(4286 #97 Mode)
Comments
Thermostat
Speaker
01 - 30
(exclude 04)*
31 No Assign 4500 to
same partition
as keypad
Thermostat
No Speaker
01 - 30
(exclude 04)*
31 Yes Assign 4500 to
same partition
as keypad
No Thermostat
No Speaker
00
[default]
00
[default]
No
*Do NOT select 04, which is the address of the 4286 Phone Module.
With no speaker connected, the speaker option must still be disabled. After
exiting the 4286 programming mode, use the # 97 speaker control menu of the
4286 and choose the
“MUTE”
menu selection. Refer to “Programming
Speaker Output Mode” on page 3-9 of the 4286 Installation Instructions for
more detail.
Field 01: Phone Panic Address
The 4286 will trigger a panic alarm by sending a panic key sequence to the
control panel when a phone panic key sequence is entered on a Touch tone
phone keypad. Refer to the “Basic Operating Guide” in this manual for
details.
To disable the phone panic feature, enter 00 [default] Otherwise:
In a system that uses addressable keypads:
1.
Select an unused device address (01-31) to be used to send phone
panics to the control panel. Assign this address to a keypad through
the control panel’s #93 device programming mode (although a
physical keypad will not actually be connected). Do not select 04,
which is the address of the 4286 VIP Module.
2.
Enter the same address in this field
In a system that uses non-addressable keypads:
Set this field to 31 to enable phone panics.