Filter
Top Products
— 8 —
HC24EO SERIES STEAMER
ELECTRICAL DATA
Model Volts KW Amp @ Amp @
1 PH 3 PH
HC24EO3 208 8 38.5 22.2
240 8 33.3 19.2
HC24EO5 208 12 57.7 33.3
240 12 50.0 28.9
480 12 N/A 14.4
SERVICE CONNECTIONS
Water Connections
No water supply connections are required, as
the steamer is lled manually.
Water Treatment
A local water treatment specialist should
be consulted before installation of steam
generating equipment.
Hardness* No more than 3 grains
Silica less than 13 ppm
Total Chlorine less than 4.0 ppm
PH range 6.5 to 8
Undissolved Solids less than 5 microns
*17.1 ppm = 1 grain of hardness
If the water supply fails to meet these standards,
it will be necessary to install a water conditioner.
The use of strainers or lters will not remove
minerals from the water.
Water Requirements
Proper water quality can improve the taste of
the food prepared in the steamer, reduce liming
in the steam generator and extend equipment
life. Water conditions vary from one location
to another. Ask your municipal water supplier
for details about your local water supply prior
to installation. Presence of sediment, silica,
excess chlorides or other dissolved solids may
lead to a recommendation for alternate form(s)
of water treatment. Test the water with the test
strip included with the steamer. Other factors
affecting steam generation are iron content,
amount of chloridation and dissolved gases.
Drain Connection
The C24EO can be congured to drain through
either the rear panel or through the bottom
base plate.
The unit is congured to be drained through the
rear panel from the factory. The unit is supplied
with a 12" length of
5
/8" ID hose. If this length is
insufcient, remove the hose and install a new
hose ordered to the desired length. The factory
5
/8" ID silicone hose part number is 557475.
Hose is sold by the foot.
See Figure 3.
Figure 3: Rear Panel Drain Connection
(Viewed with right side panel removed)
To eld congure the drain through the bottom
base plate, the 4" leg kit (part number 843889)
is required. Also required are a
1
/2" NPT close
pipe nipple (1
1
/8" long) and a
1
/2" NPT 90°
elbow, which are available through local home
improvement or plumbing supply houses.
1. Remove right side panel.
2. Remove hose barb from drain.
3. Remove knockout from base plate.