Filter
Top Products
— 11 —
HC24EO SERIES STEAMER
NOTE: Temperature Control is configured
by vendor to Fahrenheit and cannot
be changed to Celsius. The display
indicates set point temperature only.
a. Wait 3 seconds after releasing the
knob for the selection to be saved in
memory. Display will blink momentarily
to indicate temperature is saved.
b. Allow temperature to stabilize by
completing two heating cycles with
door closed.
NOTE: Temperature display on control is for
reference only. When calibrating, use
the recorded temperature from meter.
5. Record temperature reading from meter
when load light goes out.
6. Compare recorded temperature to the
temperature from table.
a. If recorded temperature is correct, no
adjustment is necessary.
b. If recorded temperature is not correct,
adjust temperature setting and re-check
the temperature reading with meter.
NOTE: If unit cannot be calibrated call your
Authorized Vulcan Servicer.
7. If correct temperature reading is not attained
after 3 attempts, call your Authorized Vulcan
Servicer.