Filter
Top Products
Heat & Glo • RED40, RED40ST • 2155-900 Rev. o • 7/12
51
Figure 12.17. Remove Mounting Plate
11. Attach new blower to mounting plate by fastening the
four screws in the appropriate locations. The side of
the blower with the label on it must face toward the
inside of the appliance. This is the direction of the air
fl ow. See Figure 12.18.
Figure 12.18. Removed Mounting Plate
12. To install new blower back into appliance, reverse the
removal procedure. Install blower assembly with the
tab toward the rear of the appliance. See Figure 12.19.
This tab must insert into slot on blower housing inside
the appliance as shown in Figure 12.20.
Figure 12.19. Blower Tab Toward Rear
Figure 12.20. Blower Tab Inserted into Slot on Blower Housing
BLOWER TAB ON
MOUNTING PLATE
SLOT ON
BLOWER HOUSING