Filter
Top Products
Heat & Glo • RED40, RED40ST • 2155-900 Rev. o • 7/1250
4. Remove screws from each end of burner assembly.
Pull burner out of appliance. Set aside.
Figure 12.11. Side Burner Screw.
SIDE BURNER SCREW
5. Remove left or right side glass pane frame, depending
on placement of blower, from bottom of fi rebox. Remove
glass pane and gaskets. Gaskets may have become
fragile from heat exposure. Handle with care. At this
point, blower and other components located under the
fi rebox are accessible.
Figure 12.12. Glass Pane Frame.
Figure 12.13. Removing Glass Pane Frame.
7. Slide fan forward slightly to release it from the fan mount
housing.
8. Locate blower power wires and unplug them from their
locations. Note these positions for reinstallation.
9. Remove blower from appliance. See Figure 12.15.
Figure 12.15. Remove Blower from Appliance.
10. Remove mounting plate from blower by removing the
four screws that hold the blower to the plate. Save the
gasket for use with the new blower. See Figure 12.16
and Figure 12.17.
Figure 12.16. Remove Mounting Plate
6. Locate the fan mount fastener on either the left or right
side of the appliance. See Figure 12.14. Remove
fastener.
Figure 12.14. Fan Mount Fastener Location.
FAN MOUNT FASTENER
FAN MOUNT FASTENER