Filter
Top Products
40
Before lighting the fireplace, be sure to do the
following:
Remove all paperwork and documents from the
fireplace.
Review safety warnings and cautions
Read the Safety and Warning Information
section at the beginning of this Installers Guide.
Double-check for gas leaks
Before lighting the fireplace, double-check the unit
for possible gas leaks.
Double-check vent terminations and front
grilles for obstructions.
Before lighting the fireplace, double-check the unit
for possible obstructions that could be blocking
the vent terminations or the front grilles.
Double-check for faulty components
Any component that is found to be faulty MUST
BE replaced with an approved component.
Tampering with the fireplace components is
DANGEROUS and voids all warranties.
A small amount of air will be in the gas supply lines.
When first lighting the fireplace, it will take a few
minutes for the lines to purge themselves of this air.
Once the purging is complete, the fireplace will light
and will operate normally.
Subsequent lightings of the fireplace will not require
this purging of air from the gas supply lines, unless
the gas valve has been turned to the OFF
position, in which case the air would have to be
purged.
NOTE: The fireplace should be run for 8 hours on
the inital start-up.This will help to cure the chemicals
used in the paint and logs.
Youve reviewed all safety warnings, youve checked
the fireplace for gas leaks, you know the vent
system is unobstructed, and youve checked for
faulty components. Now youre ready to light the
fireplace.
WARNING
PLEASE REFER TO THE USERS
MANUAL FOR ALL CAUTIONS, SAFETY,
AND WARNING INFORMATION
PERTAINING TO THE LIGHTING AND
OPERATION OF THE FIREPLACE.
!
Step 11
Before Lighting
the Fireplace
Step 12
Lighting the
Fireplace